Gebruiksaanwijzing /service van het product H304GGVVI van de fabrikant Bertazzoni
Ga naar pagina of 27
Installation, Service and User Instructions FREESTANDING GAS RANGES BERTAZZONI DIMENSIONS: 30’’ (762 mm)(W) x 253/ 16’’ (640 mm)(D) x36’’ (915 mm)(H) MODELS H304GGVCR [M7S0GTV4D(2 or 5)A] .
2 IMPORTANT - PLEASE READ AND FOLLOW -Before beginning installation, please read t hese instructions completely and carefully. -Do not remove permanently affixed labels, wa rnings, or plates fro m the product. This may void the warranty. -Please observe al l local and national codes and ordinances.
3 WARNING Read this instruction bookl et befor e installing and using the appliance. The manufacturer will not be res ponsible for any damage to property or to persons caused by incorrect installation or improper use of the appliance.
4 ATTENTION: A manual valve shall be installed in an accessible location in the gas line external to the appliance for the purpose of turning on or shuttin g off gas to the appliance WARNING: Do not use aerosol spray s in the vicini ty of this appliance while it is in operation Requirements Room ventilation – Location and v enting.
5 INSTALLATION MANUAL ANTI-TIP STABILlTY DEVICE INSTALLATION INSTRUCTIONS 1. The anti-tip bracket have to be installed to the rear wall as shown. The height for the bracket location from the floor has.
6 BACKGUARD INSTALLATION INSTRUCTION It’s always compulsory to installa th e riser even for an island installation 1) Remove n°2 screws fixing worktop as sho wn in fig.1 2) Place front part of the backguard and attach it from bottom side with the two removed scre ws (point 2) as shown in fig .
7 WORKTOP FRO NTGUARD INST ALLATION INSTRUCTIONS In order to increase the cl earance between front edge of the worktop and the burn ers for your safety it i s recomended to install the worktop frontguard supplie d with the appliance.
8 INSTALLATION SIDE-BY-SIDE TO KI TCHEN CABINET 1. This range may be installed dire ctly adjace nt to existing 36" (91.5 cm) high cabinets. IMPORTANT: Th e top border of the worktop should be at the same level of the adjacent cabinet countertop. This can be accomplished by raising the unit usin g the adjustment spindles on the legs.
9 COOKER HOOD INSTALLATION The bottom of the hood sh ould be 25 1/2 " (65 cm) mi n. to 31 1/2 " (80 cm) above the countertop. This would typically result in the bottom of the h ood being 61 1/2 " (156.2 cm) t o 67 1/2 " (171.5 cm) ab ove the floor.
10 Wiring diagram For freestanding gas range model M7S0GTV4(D,L,N)(2 or 5)A CAUTION : label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing. GAS CONNECTION All gas connections must be made accordi ng to national and lo cal codes.
11 3. Flexible Connections : a) If the unit is to be installed with flexible couplings and/or quick disconne ct fittings, the installer must use a heavy-duty, AG A design-certified commerciai flexi ble connector of at least 1/2" (1.3 cm) ID NPT ( with suitable strain reliefs) in complianc e with ANSI Z21.
12 REPLACEMENT PARTS Only authorized replac ement parts may be used in performing service on t he appliance. Repl acement p arts are available from factory authorized parts distributors. Conversion to different types of gas Before carrying out any maintenance work, disconnect the appliance from the gas and elec tric supply.
13 Fig. 9A Fig. 9B Fig. 10 Fig. 11 Follow the instruc tions below to chan ge the broiler burner nozzle: 1) Loosen the scre w and pull out the burner from the support b eing careful not to damage the igniti on plug and the thermocouple (Fig. 12). 2) Unscrew the nozzle C (Fig.
14 Models H304GGV(NE,CR,VI) [M7S0GTV4(D,L,N) (2 or 5)A] Adapting to different types of gas CAUTION: save the orifices remov ed from the appliance for future use Burner Position Injector Gas Pressure Max Rate Min Rate By-pass diam. [mm.] Type [i.w .c.] [BTU/h] [W] [BTU/h] [W] diam.
15 SERVICE & MAINTENA NCE INSTRUCTIONS Service and mainte nance only to be c arried out by an a uthorised person To replace parts such as burners, valves and electric co mponents, the appliance must be open removing the worktop. Note: if the valves must be replaced, first di sassemble the ignitions s witches wires.
16 USER MANUAL WARNINGS: Do not to cover the holes inside the oven with aluminium paper Do not to cover the burners of co oktop with aluminium paper Do not store any flammable objects o r objects unde.
17 CONTROL PANEL DESCRIPTION On the control panel, small s ymbols show the function of each knob or key. H ere as follows are t he several controls that a cooker can have: the symbol shows the dis position of burner s on the worktop, the full dot identifies the burner in object (in this case the front burner on the right).
18 WARNING: check the position of the burne r caps before operation. Correct usage of pans: - Dry the bottom of the pan before placing it on the hotplate. - Use pots with a flat, thick bottom, except for wok cooking. - When using the burners, ensure that the handles of the pans are correctly position ed.
19 - Electric ignition In this case, first open the oven door, then t urn the knob to the maximum temperatur e setting. Then pre ss the thermostat knob to start the gas flow and the ignitio n spark. Wait about 10 seconds after the burner has been completel y lit and then release the knob.
20 To activate the convection fan use t he selector placed on control p anel. CONVECTION GAS OVEN COO KING TABLE TEMP °F/ °C HEIGHT MINUTES MEAT PORK ROA ST 320 -340/160-17 0 3 70-100 BEEF ROAST (YO.
21 ATTENTION: To use broiler please utilize the proper br oiler grid installed inside the grid enamelled tray supplied with the applia nce; broiler tray s hall be supported by oven grid. WARNING: As with the ov en, the broiler must be lit with the door com pletely open.
22 AFTER SALE SERVICE: Please note here belo w details for after save service. Refer to warranty certific ate for warranty condiftions Dealer /Importer: Name, address, phone MANUFACTURER: BERTAZZONI SPA VIA PALAZZINA, 8 – 42016 – GUASTALL A (REGGIO E.
23.
24.
25.
26.
27.
Een belangrijk punt na aankoop van elk apparaat Bertazzoni H304GGVVI (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Bertazzoni H304GGVVI heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Bertazzoni H304GGVVI vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Bertazzoni H304GGVVI leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Bertazzoni H304GGVVI krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Bertazzoni H304GGVVI bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Bertazzoni H304GGVVI kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Bertazzoni H304GGVVI . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
